The extra tier on drone..
Ok I ordered another mainplate (Come with upper and bottom plate) for the T810. I only needed the lower plate as was adding another level below the bottom plate. The upper plate came in handy though, as I was able to cut it into two rectangular plates for mounting the landing gear motors as you will see in images.
I installed on to the bottom of this extra main plate Tarot Hexa-copter Power Distribution Board Signal Hub - TL6X002 to keep the job tidy and neat. On top of this hub you will see I added the Tarot TL8X002 Auto Landing Gear Controller to connect the 2x landing gear motors too. You will see I did a bit of customisation to the power hub, so I could connect the power lines from the ESC's using bullet connectors. Good if you need to remove bottom plate again.
You will also see in photo's a 8 in 1 Throttle Calibration Hub, which I'll show a pic of later. I think this being the best way to calibrate ESC's.
Tarot T810 - DJI Naza M V2 - DJI Datalink - DJI OSD - DJI Zenmuse H4-3D - FrSky D8R-II PLUS - ImmersionRC TX